• Flat helix wire design for high current application
  
• Lowest DCR, lower loss, less heat generated.
  
• Winding to core isolation 500 Vrms.

• Magnetically shielded
• Very high current- up to 10 Adc saturation curren
• Low DCR

• Magnetically shielded
• High current- up to 6.5 Adc saturation current
• Very low DCR
• Tape & Reel package

• 130℃ maximum operation temperature
  
• Low profile in horizontal package available on request
  
• No base version available

• Base material meets UL 94V-0 flammability requirements

• Base material meets flammability requirements of UL94V-0
• Characterized for general purpose use and ripple filters
• No base version available

• Operating temperature Range 0˚C to + 105˚C
  
• Withstanding voltage: 500V AC
• Maximum power dissipation at 25˚C, 0.605 watts

• AC Line Filters EMI/RFI Common Mode Chokes
  
• Prevents EMI and RFI noise emission, such as electromagnetic interference (EMI) & radio frequency interference(RFI)
  
• Protects AC side from the effects of switching regulators
  
• Wide range of available inductances and current ratings

• AC Line Filters EMI/RFI Common Mode Chokes
  
• Prevents noise emission, such as electromagnetic interference (EMI) and radio frequency interference(RFI)
  
• Protects AC side from the effects of switching regulators
  
• Wide range of available inductances and current ratings

• Noise Countermeasures Common Mode Chokes
• Use new material for higher impedance under high frequency range noise suppression.
  
• This series employs two outer magnetic path limbs design with windings on the center magnetic path limb of double-square shaped closed magnetic circuit ferrite core to reduce leakage flux.
• Wide range of available inductances and current ratings

‍

• 3000 Vrms gate to drive winding test
• Operating frequency from 50KHz to 500KHz

‍

‍

• Measuring frequency 50/60Hz
• Insulation: 500V DC > 100M ohm
• Operating temperature -25 deg C to 85 deg C
• Primary rated current 5A ac

• Secondary furnished
• Designed for switch mode power supply
• 2500 Vrms primary to secondary Hi-pot
• Frequency range 20KHz to 200KHz
• Epoxy coated

• Primary and secondary furnished
• Designed for switch mode power supply
• Encapsulated with plastic housing and potting
• 3750 Vrms primary to secondary Hi-pot
• Frequency range 20KHz to 200KHz

• Secondary furnished
• Designed for switch mode power supply
• 2500 Vrms primary to secondary Hi-pot
• Frequency range 20KHz to 200KHz
• Encapsulated construction
• Customize available

• High current - primary rated for 35 Amps
• Designed for automatic pick and place
• Operating frequency range up to 200kHz
• Low profile - height at 7mm maximum

• High current - primary rated for 35 Amps
• Designed for automatic pick and place
• Operating frequency range up to 200kHz